Step one would be to first discover the correct kind of interfacing that is useful for you form of interfacing fabric. Mostly these instructions is going to be on the rear of the pattern envelope that you bought. Should you be creating your own patterns in your own home, it would be better to first test what interfacing will continue to work on the type of fabric you will be using. You simply need a small part of fabric and measure a block, fuse the piece and measure it again to find out what the different shrinkage was.
Now to me that is certainly doing sewing at home and as being a hobby I don’t have a fusing press or fusing machine similar to most clothing manufactures have. I still need to use to old reliable method that worked in my opinion.
The equipment that you would need is definitely the following:
3. Correct interfacing
I am aware other individuals utilize more equipment however i have used this method for many years and never had any problems.
Steps to follow:
1. Eliminate your patterns components of the fabric and interfacing. Some individuals will suggest that you cutout you interfacing smaller than you interlining fabric supplier and once you steam iron it, it won’t adhere to your cloth or ironing board. That is up to you, you will be aware best how accurate you work.
2. Ensure before ironing the various components together that the glue dotted side are facing the incorrect side of the fabric. This is quite important part as if you iron the various components together and it’s a bad sides it tough to get rid of the interfacing again, probably also depend upon the type of interfacing and glue.
3. Place a cloth within the parts and make certain you iron is hot. I came across that steam doesn’t always work effectively thus i use only a small amount of steam setting on the iron. I use a cloth as a fabbric iron can leave shiny marks on non woven interfacing fabric and you also don’t want that.
4. When pressing the iron in addition to the cloth ensure that it stays for a couple seconds on a single spot before moving onto another section. I also do small sections at one time no matter how small the various components are.
5. After ironing the parts leave it to cool down for any bit before utilizing it to carry on sewing your garment. I find it wise to fuse all the interfacing parts before actually start sewing the garment.